Our Commitment to Privacy:

Your privacy is important to us. To better protect your privacy, we provide this notice explaining our online information practices and the choices you can make about the way your information is collected and used. To make this notice easy to find, we make it available on our homepage and at every point where personally identifiable information may be requested.

The Information We Collect:

This notice applies to all information collected or submitted on the ICF LLC. website. On some pages, you can inquire about products, make quote requests and apply for credit. The types of personal information collected at these pages are: Name, Address, Phone, Banking Information etc.

The Way We Use Information:

We use the information you provide about yourself when placing an order only to complete that order/request. We do not share this information with outside parties except to the extent necessary to complete that order/request.
©2017 ICF Sales LLC

BuildBlock Hardwall Concrete Faced ICF Walls
BuildBlock HardWall Block
BuildBlock HardWall uses BuildLock Knockdown ICFs to create an insulated ICF wall on one side and a bare concrete wall on the other.
This system offers the same or greater insulation value when used with ThermalSert Insulation Inserts inside the wall cavity against the outside wall panel. This system is used primarily in commercial applications where no flammable material may be present such as emergency stairwells and elevator shafts as well as warehouses and industrial buildings where utility and impact resistance is required.
The initial
BuildBlock HardWall solved this challenge by using BuildLock ICF panels combined with web bridges and the webs normally molded into EPS panels. Plywood or other suitable materials is cut and attached to the assembled forms as they are stacked. This worked well, but left the full attachment strips exposed and required significant finishing to hide them.
BuildBlock HardWall Connector
BuildBlock Hardwall & Cap Side Oblique
The new BuildBlock HardWall connector extends a BuildLock web bridge 2-1/2 inches to the edge of what is normally the EPS foam. The BuildBlock HardWall connector connects to any size of web bridge. The outer edge of the connector provides an attachment point for wood, cement board, or other suit able forming material. The end of the connector also contains a removable cap with a guide hole for screws. Once the wall is poured and the forming material is removed the cap may be left in place as an attachment point for wall finishes, or removed and the ½-in hole filled with patch or other material.
The new HardWall Connector provides the ultimate flexibility to finish the concrete wall. Additional insulation may be added by adding
BuildBlock ThermalSert sheets inside the wall cavity against the outside wall panel.
BuildBlock Knockdown ICF forms have multiple uses aside from the traditional ICF form. They have been used to build footing forms, pilasters and other custom structural and architectural pieces. One innovative way to use these forms, and save labor at the same time is to attach sheathing (either cement fiber board, plywood, OSB or another sheet material to the web inserts without the foam panel molded onto them.
Check us out on
Fully stocked warehouse ready for pick-up or immediate Delivery to your job site. Free Quotes!
PO Box 969
30 West State St.
Sherburne, NY 13460
Phone: 607.427.2046
Hours: Mon - Fri 7am - 4pm
INSULATED                CONCRETE              FORMS
CNY Factory Warehouse
National Distributors